2box forum: accident-free since the last one.
Started by Walse, April 03, 2018, 04:35:30 PM
Quote from: Walse on April 03, 2018, 04:35:30 PMI have made sd card mod on Drumit Three without using a heat gun.In essence I follow all steps suggested on JMan post about sd card mod on Drumit 3, but I don't used any heat gun (I don't own any). I simply lifted the motherboard on the side that has card slot, just enough to extract sd card, and replaced it with the extender card. It was very easy and fast. Everything works perfectly!!!Obviously, any mod similar is done at your own risk.
Quote from: Jman on April 04, 2018, 04:25:43 PMDid you test the card in the extender before putting the module back together? Because that was the one part that threw me off a bit. I posted this earlier: When I tested the card in the slot with the module open I got a NO USB connection type msg. on the screen, no boot. However, after I installed one of the screws that hold the board to the top case everything booted like normal with the module open. So I assume the screw is needed for grounding the board .....
Quote from: Walse on April 05, 2018, 10:43:57 AMFortunately I read your post about sd card mod before opening my drumit module. Thanks to your help, I installed one of the board screws before any testing.Thanks! I don't think I would have had the courage to make sd card mod without reading your post.
Quote from: kjob3022 on April 07, 2018, 06:34:50 AMNice work,I'm gonna pick up a unit from edrumcenter for 799.00+ship. today but I need to get an extender or at least know they're available,thanks,Ken
Quote from: Michael on May 19, 2018, 12:10:52 PMProbably I am just being blind, but I cannot find the initial post mentioned above from JMan on doing the mod on Drumit3 ... Could you point me there?