« previous next »
Pages: [1]

Author Topic: Tom splitter  (Read 1026 times)

emilianoheyns

  • Newbie
  • *
  • Posts: 10
  • Karma: 0
    • View Profile
Tom splitter
« on: September 18, 2021, 06:03:43 PM »
I want to install 3 drum-tec trigger tubes (https://www.drum-tec.com/drum-tec-trigger-tube-pro-3-pack) by splitting off the rims of my toms. I currently have 3 roland pdx pads for toms 1-3. When splitters are discussed in relation to roland gear, I see it mentioned that I may need special splitters with a resistance because of the way the roland pads are set up, but I'm not sure whether these are needed for roland pads or for a roland module.
Logged

Deve Loper

  • Full Member
  • ***
  • Posts: 183
  • Karma: 48
    • View Profile
Re: Tom splitter
« Reply #1 on: September 20, 2021, 08:03:50 AM »
Hi. Any normal Y  trs to 2 x ts cable will work. The special one is for the rol module.
Cheers.
Logged

emilianoheyns

  • Newbie
  • *
  • Posts: 10
  • Karma: 0
    • View Profile
Re: Tom splitter
« Reply #2 on: September 20, 2021, 09:00:07 AM »
wouldn't such a splitter be TRS to TS + RS? But I suppose anything that advertises itself as a tom splitter without a resistor should do the job then. Thanks!
Logged

Karbonfaiba

  • Jr. Member
  • **
  • Posts: 55
  • Karma: 9
  • Analysis Paralysis!
    • View Profile
Re: Tom splitter
« Reply #3 on: September 20, 2021, 12:19:28 PM »
I'm using 4 of the Hosa YPP-117

Works flawlessly. No need to spend the extra money on the Drum-tec ones with the resistor in my experience.
Logged

Deve Loper

  • Full Member
  • ***
  • Posts: 183
  • Karma: 48
    • View Profile
Re: Tom splitter
« Reply #4 on: September 21, 2021, 07:34:35 PM »
"wouldn't such a splitter be TRS to TS + RS? "
Yes, -from-  ts and rs, but -to- two times ts.
 :)
Logged
Pages: [1]
« previous next »