Author Topic: Hello, to the old topic: Problems with rotary control  (Read 232 times)

teletom007

  • Full Member
  • ***
  • Posts: 183
  • Karma: 14
  • sn/ 02489
    • View Profile
Hello, to the old topic: Problems with rotary control
« on: March 11, 2019, 03:02:36 PM »
Hello, to the old topic: Problems with rotary control

With me it was so bad that I had to do something. Inquired at Hyperactive revealed:
Submit the part, ask for a quotation, exchange the defective part, duration approx. 10 working days.

Now I've given the Drumit5 to my colleague with a request for view. He has ordered such a knob and will redeem him the week. This is for a skilled "solderers" probably no problem.
If my Drumit runs again I will here times the source and possibly some pictures set. The material costs should be in the range of a few euros.

Problems with rotary control
«On: January 18, 2016, 12:06:52 pm

Good morning,

Have a 2box Drumit5 set and am so very satisfied for about 2 years. For a few days, however, there are problems with the knob, with which you select the drumsets (the left below the display). When turning, he sometimes slides from set 7 directly to set 15 (example). It is as if the controller no longer recognizes the individual steps. I know that from some hi-fi amp volume controls that did not respond when you were spinning very fast.