I normally use a goedrum controller but was trying out an Alesis realhat pedal. Could not get the Raw adjustment to move when Def was selected but it did work with selecting Alehh and would calibrate correctly , set Raw to around 854. I saved my settings (and yes, save is enabled) then after powering off then back on the module would only play a closed hat sound and no pedal function whatsoever until I would go back to the hi hat calibration page. The Raw would hang at 954 and seemed like it wasn’t recognizing the pedal until I would select either 2box or Def, then reselect Allehh again then it would recognize the pedal (you could see the Raw data moving from its closed 854 to open 954) and start working again until powered down. Happened every time I would restart. Once set it would work fine until the next power down them repeat.
Another issue that happened occasionally is the cymbal 3 (single zone) with one cable in the 3a slot nothing in 3 b slot would want to play a choked cymbal sound. I tried different cymbal pad types (wound up using Cyps) and having only one + in the middle setting. Again only happened when powering off and back on. Not every time like the hat.
Anyone have any ideas as to what could be going on. Thanks
Another issue that happened occasionally is the cymbal 3 (single zone) with one cable in the 3a slot nothing in 3 b slot would want to play a choked cymbal sound. I tried different cymbal pad types (wound up using Cyps) and having only one + in the middle setting. Again only happened when powering off and back on. Not every time like the hat.
Anyone have any ideas as to what could be going on. Thanks