Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Krillo

Pages: 1 2 [3] 4 5 ... 10
General 2Box Drumit 3 Forum / Re: What hihat would you suggest getting?
« on: November 25, 2018, 05:36:11 AM »

When you say bad response... do you mean the pedal or the e-pad of RHH-135?

If it is the pedal...the 2box hh could be an alternative...but maybe there are even better alternatives:
1. The Roland’s or a ATV  hh. (ATV needs a Zourman module)
2. Stealth hh Kit.(then you could use the existing Yamaha pads)
3. 2box hi-hats

Best regards

Anders /

It's mostly the pedal that sucks, and I hope it's the Yammie and not the module. The pad itself does have quite a hot spot, but the pedalfunction is what makes it suck.

Does additional boxes improve performance?

General 2Box Drumit 3 Forum / What hihat would you suggest getting?
« on: November 24, 2018, 09:09:07 AM »
Hi all,

I've had the drumit3 now for over 3 weeks. I'm not happy with the response of the Yamaha RHH-135 hihat. I've gone through the settings enough to be familiar with them, so calibration is no longer the issue.

I'm looking for suggestions on which hihat to get. I would guess the 2box hihat would perform the best with the drumit3, but would like to have your input. Which hihat do you suggest I get?

Here's an example of the hihat playing I do on acoustic drums.
Attempting this style of playing on the Yamaha hihat is just frustrating.

General 2Box Drumit 3 Forum / Re: Latency Measurements drumit3
« on: November 24, 2018, 07:09:39 AM »
My standard test is snare head, triggered by a piezo whose output is split - one cable direct to the interface, the second to the snare input with a direct out to the interface. The latency is the difference between the same wave form from each input.

That's how I make my tests too.

General 2Box Drumit 3 Forum / Re: ddrum4 / ddrum3 pads with drumit three ?
« on: November 03, 2018, 08:10:39 AM »
Edit: Got the module. ddrum3 precision pads and cast presicion pads work fine with the drumit3.

General 2Box Drumit 3 Forum / Re: Latency Measurements drumit3
« on: November 03, 2018, 07:23:19 AM »
Thanks for the info!
However, I got the module and have done some measurements. Results are as follows:

Snare pad was Yamaha XP120SD
Snare head 6ms
Rimshot and x-stick gave similar results: at 3ms you have response, but the signal is of lower level. At 9ms full amplitude of signal is produced by the module. Not sure what this is about. Similar result with hihat pedal, see below.

Tom pad was a 10" ddrum3 precision pad. These pads used to produce too hot signal for the drumit5, this have changed in the drumit 3 and the level from these pads are no longer an issue.
Triggersetting "actr1" gave  3,5 ms

Hihat pad used was Yamaha RHH-135
HH open bow 5,5ms
HH open edge 6-7,5ms

HH closed bow 5,5ms
HH closed edge 6ms

The pedal function is what stood out negatively. 11-33ms with that lower signal appearing at 11ms and then the full signal at 33ms.

By the way I will be looking to change hihat pad for something better.

Ride pad was Yamaha PSY-155
Bow 3,5-5,5ms (quite a lot of jitter / variance)
Edge 5 5ms
Bell 3-5,5ms (variance here too)

Finally I scrolled through all triggertypes to see what the difference between them were. Pad used was 10" ddrum3 precision pad. Module was in that menu location when testing. I have read that this might affect performance, but I couldn't detect any abnormal performance.

kick1 4ms
kick2 4ms
padpp 4ms
papss 4ms
papsy 4ms
padps 4ms
actr1 3ms
actr2 3,5ms
actr3 4,5ms
rubh1 3ms
rubh2 3ms
rubh3 3,5ms

General 2Box Drumit 3 Forum / Re: Hiss.....
« on: October 20, 2018, 01:22:28 PM »
It's normal. Most samples you can buy are probably noise reduced by some plug-in.

General 2Box Drumit 3 Forum / Latency Measurements drumit3
« on: October 18, 2018, 12:48:29 PM »
I was wondering if someone owning the drumit3 would please measure the latency? I wonder if it was improved over the drumit5, which I measured and posted here on the forum.

I emailed 2box about the dd3 precision pads. They said to add a 47k resistor in series,  otherwise they are too hot as for the drumit5 also.

your music / YouTube channel
« on: September 09, 2017, 02:18:03 PM »
Hi all,

I now and then post jams (Ninjam) on YouTube, my channel:

Review: omg this is completely useless  :o Don't download.

Sharing drum sounds - wav / aiff / rex / Re: Free VSTi from Sennheiser
« on: April 19, 2015, 05:47:07 AM »
I've downloaded drummica a few times and always get a corrupted zip-file :(

The dd4 hihat sounds are just one layer, so I think it would be silly to do a DSND...

(Copied from Gearslutz)

ALL of the content on this website is for FREE royalty free use by anyone for anything.

General 2box Drumit 5 forum / Re: What's a fair 2nd hand price?
« on: February 20, 2015, 05:39:50 PM »
I paid £800 for a Mk1 kit hardly used less than 6 months ago .... But then also paid another £300 for new Mk2 rack as mk1 rack not strong enough for gigging.

Ok, thanks that's equal to 14283 SEK. Interesting...

General 2box Drumit 5 forum / What's a fair 2nd hand price?
« on: February 20, 2015, 12:16:18 PM »
Hi guys,

What do you consider a fair secondhandprice for a complete MK2 drumit5-kit to be? There is one out for sale, but I think the price too high. ( In Sweden) It's less than a year old and not much used.

Pages: 1 2 [3] 4 5 ... 10