News:

2box forum: accident-free since the last one.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - larsoes

#1
Does anyone know if the hi-hat from the Speedlight kit, will be sold seperately?
#2
You should contact 2box via messenger, maybe it's a hardware problem. I had my memorycard shifted due to lacking sounds.
#3
General 2Box Drumit 3 Forum / Re: Help with Lustark's SDSE
September 09, 2019, 08:31:07 AM
Contact Lustark himself. I did so, since the program was very slow. He is very friendly.
#4
General 2Box Drumit 3 Forum / Re: Choke
December 03, 2018, 04:27:31 PM
By the way, i contacted 2box via messenger, they were very helpful.
#5
General 2Box Drumit 3 Forum / Re: Choke
December 03, 2018, 04:18:21 PM
I finally found out why :sorry, I just realized that the hold and decay was set wrong.... If you alter these values the choke no longer works.
#6
General 2Box Drumit 3 Forum / Re: Choke
November 29, 2018, 06:25:57 AM
I'm using my old cables from my td20 (trs). The edge triggers perfectly.
#7
General 2Box Drumit 3 Forum / Re: Choke
November 28, 2018, 04:18:55 PM
Frustrating! I can't get anything to choke, tried my old cy-8, nothing will do the trick...
#8
General 2Box Drumit 3 Forum / Re: Choke
November 27, 2018, 02:38:24 PM
Thank you I'll try that
#9
General 2Box Drumit 3 Forum / Re: Choke
November 22, 2018, 06:33:39 PM
The module is a Drumit3. I plugged it in cymbal 2 using both a&b. Bell, bow and edge working fine.
#10
General 2Box Drumit 3 Forum / Choke
November 21, 2018, 03:13:31 PM
I'm having difficulty with getting my cymbals to choke. The don't seem to respond... I have a cy15r ride, and 2 yamaha pcy 155
#11
General 2Box Drumit 3 Forum / Re: module issues ???
October 27, 2018, 07:08:36 AM
I had that problem. I contacted 2box via messenger. The module was send to repair and now it's working perfectly!
#12
I just purchased the drumit3 and downloaded enerd sounds, great. But I have a roland cy-15r and can't get it to trigger the bell sound right. It has two outputs. I use cypsv, but can only get the edge and center to trigger right. Some advice?