Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Rmiller

Pages: [1]
1
General 2Box Drumit 3 Forum / Hi hat calibration issue- maybe
« on: March 03, 2019, 12:37:21 AM »
I normally use a goedrum controller but was trying out an Alesis realhat pedal. Could not get the Raw adjustment to move when Def was selected but it did work with selecting Alehh and would calibrate correctly , set Raw to around 854. I saved my settings (and yes, save is enabled) then after powering off then back on the module would only play a closed hat sound and no pedal function whatsoever until I would go back to the hi hat calibration page. The Raw would hang at 954 and seemed like it wasn’t recognizing the pedal until I would select either 2box or Def, then reselect Allehh again then it would recognize the pedal (you could see the Raw data moving from its closed 854 to open 954) and start working again until powered down. Happened every time I would restart. Once set it would work fine until the next power down them repeat.
Another issue that happened occasionally is the cymbal 3 (single zone) with one cable in the 3a slot nothing in 3 b slot would want to play a choked cymbal sound. I tried different cymbal pad types (wound up using Cyps) and having only one + in the middle setting. Again only happened when powering off and back on. Not every time like the hat.
Anyone have any ideas as to what could be going on. Thanks

2
General 2Box Drumit 3 Forum / Module problem?
« on: November 18, 2018, 01:32:58 AM »
Whe playing the ride and kick simultaneously, the ride decays as though it’s being cut off. Also happens when playing the snare and ride together. Doesn’t happen with any other pads, ride rings and decays correctly. I have swapped cables, changed samples, adjusted settings etc. but to no avail. Anyone else experience this or any ideas?

3
General 2Box Drumit 3 Forum / Drunit3 outputs
« on: May 12, 2018, 01:12:10 AM »
Anyone know the specs for the outputs 1-4; line level, instrument level, balanced, unbalanced? I understand all the inputs need trs cables to accommodate the zones, but are the outs balanced and do better with trs cables due to their grounding/noise eliminating capabilities?

4
General 2Box Drumit 3 Forum / A and B cymbal inputs
« on: April 27, 2018, 09:57:59 PM »
I have three 3 zone cymbals (two 14’s one 16) and will use 1 as a ride and 2 for crashes. They each have 2 outputs per pad  (Pearl, Simmons, Alesis types, not Rolands) and am wondering if the B inputs will work for them and that they are able to use a crash type cymbal with a bell or would they need to be rides only. Not sure if this makes sense. Thanks

Pages: [1]