Messages

1

General 2box Drumit 5 forum / Re: Module not being read through laptop

« on: January 14, 2022, 07:04:01 PM »

Idk what to say, the device was not recognized on Mac earlier when I did the exact same thing to access storage as I did on Windows (hold left button upon power up). Same wire for both.

I will give the manual a read and try understand some things a bit clearer. Thanks once again for your replies.

2

General 2box Drumit 5 forum / Re: Module not being read through laptop

« on: January 14, 2022, 03:26:13 PM »

Thanks, I'm not really sure what most of that means but I guess I'll have to try figure it out if I want to make sure I need a different module.

The module doesn't respond via USB to macOS either, I'm guessing that the SD card is formatted to windows or something

Thanks again

3

General 2box Drumit 5 forum / Re: Module not being read through laptop

« on: January 14, 2022, 12:04:30 PM »

Oh ok, thanks again for the reply. That's a big downer.

Would you have any suggestions as to how I can optimize the module for use as a midi controller or is it just trial and error? I tried connecting the module via midi to an interface yesterday but the program I'm trying to use (Clone Hero) didn't recognize any triggers when I tried to map them. My next attempt will be to maybe try everything through MacOS as this was all done on windows.

4

General 2box Drumit 5 forum / Re: Module not being read through laptop

« on: January 14, 2022, 10:05:20 AM »

Thanks for your help man, I have done that and my laptop now reads the device and I can look at storage. However I am trying to get the module to be read by Clone Hero which is still not happening. Perhaps this is an issue with clone hero itself but I am not sure. I think there may be a problem with usb midi as when I plug the device in via usb in 'normal' mode or in the usb mode like you mentioned (holding the left button), the usb midi light does not light up.

5

General 2box Drumit 5 forum / Re: Module not being read through laptop

« on: January 13, 2022, 06:41:47 PM »

Has this always been the case? Is the the first time you're trying to connect to USB? What module is it?

It is the first time I can recall plugging it in via usb to laptop, the module is a 2box Drumit 5.

Hi. Maybe too obvious, but do you hold the left button over the display when you switch on?
Thats how to get into usb mass storage mode.
Best, Deve.

Nothing happens when I hold this, there's also no light on the 'usbmidi' letters when I plug it into the laptop

6

General 2box Drumit 5 forum / Module not being read through laptop

« on: January 12, 2022, 03:41:37 PM »

Hey guys, when I plug the module via usb there is no response from my laptop as in the device isn't recognized. Does anyone have any idea how I can fix this?

7

General 2box Drumit 5 forum / Re: Which trigger settings to use for Jobeky Drums and cymbals with Drumit 5 mkii

« on: December 17, 2021, 12:50:09 AM »

i could do with this info too if possible

8

General 2box Drumit 5 forum / Hi Hat issues

« on: December 14, 2021, 03:36:04 AM »

Hi guys, newly registered trying to get my kit together and have lots of newb trouble even though I've had my kit for years.

The other day I was playing along with my 2box when I noticed the hi hat had become far less synchronised than I found before. It includes much more volatile  velocity, as well as some non-triggering also. The opening and closing transition of the hat has also gotten much worse, so playing with any dynamics has become much more difficult or impossible.

Could anyone direct me to how to solve this issue? I have a lot of work to do on the kit, and this is my first foray into the forum. Hoping I can learn a lot and be apart of the community.