Messages

Is there a way to edit the Empty.dkit file using the PC 2Box software?

Ive looked all over the forums and cant find a way to load or edit the single kit file on the PC.

Thanks in advance.

That note about the two additional 2Box libraries (Hard rock and vintage) is blowing my mind. How can we get these to be released? I'm opening my wallet now.

BTW that brief article on the studio was really great.

Anybody connect a GoPro up to a 2box module? If so, what is the best configuration?

Ive been thinking to connect Out 1+2 to the Mic input to the GoPro camera. Is there a way to specifically set the volume of the out 1+2 so that it does not make the input clip on the GoPro?

I know there is the 1+2! setting but where do you set the level on this?

Thanks in advance for the help.

I did some more fiddling with this today and got it to work. The problem wasn't the number of bits but rather the number of output channels on the wave files. For my sounds there are 7 outputs and they had to be converted to stereo.

After doing that, I was able to use both the 2box and dsoundtool software to create the DSND files.

Thanks for the info. 

Is it possible to take the raw BFD wav files and dump them straight into the 2box sound editor to produce a DSND file?

I tried doing this but did not have an expected result.

I also tried with dsoundtool but got an error that the wave files were not of the correct format.

Thanks in advance for the answer to the newbie question but Im just trying to understand the details of why this will or won't work.

Just to follow through on this, I did some addition tests and found out that the hi hat cymbal is not functioning properly.

Got it! Thank you for the help!

Does anybody have access to the Test HiHat.dsnd sample and can either post or send it to me?

I have been trying all of the old links on the forum and they don't work.

Thanks in advance.

My hihat is stuck only triggering the open sound. I cannot get the closed sound with the pedal.

Ive searched the forum and tried the obvious (switch cables, calibrate) but nothing changes.

***On the os 1.26 hihat calibration page, I don't get any levels registered (9****) as shown on page 25 of the manual. Is this correct?***

Any ideas on how to fix this?