i understand the output ie bus 1234 etc kick snare toms cynbals hiat, what i want to know, or should say i think, every output is a "stereo output" so bus 1 is stereo bus 2 etc so my question is if you pan the toms in the module and assign toms to bus 3 can you use a split cable ie tip sleeve and ring sleeve put them into there own channels on mixer say channel 1 on the mixer panned left channel 2 panned right would this work?
in fact you're wrong ... all outputs are mono ... if you want a stereo bus it s 1+2 or 3+4 ...
You can also config the headphone out to be effectively 5+6 too! It’s a work around but it works!
ok thanks i thought they were all trs inputs? and outputs?
They are balanced outputs, so they use TRS but only carry a mono signal