stereo from OUT1 and OUT 2

[snydley]

Is there any way to make Out 1 channel right, and Out 2 channel left so I can have a stereo monitor system? I have a small PA that I use with my 2Box and I would like to do this and then set different balances on my 4 toms so I can have my left most tom coming through the left speaker and  right most tom out of the right, balancing things so when I do a fill from left to right the sound follows the direction of my playing? I see how I can balance each pad, but I can't figure out how to assign the individual outputs on the brain to be either left or right. Or do I have to do this with the headphone jack and make a Y cable with a TRS jack on one end and 2 TS jacks on the other ends. I have 2 QSC Ksub subwoofers, a K12 speaker on one pole and a Behringer D212 on the other one. Right now I just run it mono and jump the signal from one side to the other, but I could just as easily run them separately if I could figure out how to assign L and R to 2 outputs on the brain. Can this be done?
Thanks,
Snyde

[BURNIN AMBITION]

i have done that. i dont remmeber exactly the settings, i can check them tomorrow, but i have a thread somewhere here. if you search for output channels you should find it. otherwise ill check it tomorrow and tell you. i have all toms kick and snare from right and all cymbals from left. i use 2 outputs

[snydley]

Thanks for the reply. I would appreciate it if you would check for me. I did a search for it, then a search for your name and didn't find the thread you mentioned. If you would post a link to that thread or write the instructions in a new post I'd sure appreciate it.
Thanks,
Snyde

[BURNIN AMBITION]

unit section, in the put screen, put in the out12, 1,2!
and in the intf screen, if you want for example the toms to go to out 1, put bus 1, if you want the cymb1 to go to out 2, choose bus 2
that is all. cheers

[snydley]

Thanks, got it working now!
Snyde

[BURNIN AMBITION]

glad i helped. enjoy your kit mate