Author Topic: This is an output question  (Read 240 times)

gorsepig007

  • Newbie
  • *
  • Posts: 17
  • Karma: 2
    • View Profile
This is an output question
« on: November 26, 2018, 05:53:10 AM »
i understand the output ie bus 1234 etc kick snare toms cynbals hiat, what i want to know, or should say i think, every output is a "stereo output" so bus 1 is stereo bus 2 etc so my question is if you pan the toms in the module and assign toms to bus 3 can you use a split cable ie tip sleeve and ring sleeve put them into there own channels on mixer say channel 1 on the mixer panned left channel 2 panned right would this work?

edtc

  • Hero Member
  • *****
  • Posts: 1154
  • Karma: 49
  • 2-Box S/N 01155
    • View Profile
Re: This is an output question
« Reply #1 on: November 26, 2018, 10:59:58 AM »
in fact you're wrong ... all outputs are mono ... if you want a stereo bus it s 1+2 or 3+4 ...

welshsteve

  • Sr. Member
  • ****
  • Posts: 474
  • Karma: 13
    • View Profile
Re: This is an output question
« Reply #2 on: November 26, 2018, 11:56:35 AM »
You can also config the headphone out to be effectively 5+6 too! It’s a work around but it works!

gorsepig007

  • Newbie
  • *
  • Posts: 17
  • Karma: 2
    • View Profile
Re: This is an output question
« Reply #3 on: November 27, 2018, 04:35:48 AM »
ok thanks i thought they were all trs inputs? and outputs?

paulf707

  • Full Member
  • ***
  • Posts: 106
  • Karma: 3
    • View Profile
Re: This is an output question
« Reply #4 on: November 27, 2018, 06:35:59 AM »
They are balanced outputs, so they use TRS but only carry a mono signal