Author Topic: Module stand/arm...  (Read 2336 times)

b

  • Newbie
  • *
  • Posts: 26
  • Karma: 0
    • View Profile
Module stand/arm...
« on: May 10, 2010, 08:21:58 PM »
Has anyone else had this happen?
The holes on the plate section have bent out to become bigger than the screws that hold it in place. This just makes the brain fall off the arm. If you look at the photo you can see what I mean.




Baby Samus

  • Sr. Member
  • ****
  • Posts: 370
  • Karma: 16
    • View Profile
Re: Module stand/arm...
« Reply #1 on: May 10, 2010, 08:37:39 PM »
No it has not happened to me.  If it does I will of course let everyone know...

b

  • Newbie
  • *
  • Posts: 26
  • Karma: 0
    • View Profile
Re: Module stand/arm...
« Reply #2 on: May 10, 2010, 08:49:07 PM »
thanks for your input samus.

puttenvr

  • Hero Member
  • *****
  • Posts: 1055
  • Karma: 20
    • View Profile
Re: Module stand/arm...
« Reply #3 on: May 11, 2010, 03:01:31 PM »
Why did it bend out?
Is there any force applied to the plate section?
I mean: it can change automatically

b

  • Newbie
  • *
  • Posts: 26
  • Karma: 0
    • View Profile
Re: Module stand/arm...
« Reply #4 on: May 11, 2010, 04:38:07 PM »
I have no idea. It was okay, and then module starting wobbling so I tried to straighten it up and then it just fell off in my hand.

puttenvr

  • Hero Member
  • *****
  • Posts: 1055
  • Karma: 20
    • View Profile
Re: Module stand/arm...
« Reply #5 on: May 11, 2010, 05:07:12 PM »
Strange
2Box should send a new one for that

Baby Samus

  • Sr. Member
  • ****
  • Posts: 370
  • Karma: 16
    • View Profile
Re: Module stand/arm...
« Reply #6 on: May 13, 2010, 07:50:43 PM »
Perhaps the screws were tightened too much?  This could cause threading of the screw and even damage to the plate holes so that is a possiblity...