PHONES Used as split output 7-8?

[mcrackins]

Question regarding Phones used as Output. I have 1/4 to 2 x 1/4  stereo splitter plugged into the PHONES input. I'm wanting to split the signals so they are independent.

I have bus left cymbal bus assigned to bus 7 and right cymbal assigned to bus 8. However the separate channels going into the DAW are sending the signal from either cymbal to both the DAW input channels.

Do I need a different splitter to achieve output separation from the PHONES channel?

I have done the UNIT setting correctly.

UT1.2 parameter to 1+2! and the the PHONS parameter to 7+8!

Thanks

[Jman]

Question regarding Phones used as Output. I have 1/4 to 2 x 1/4  stereo splitter plugged into the PHONES input. I'm wanting to split the signals so they are independent.

I have bus left cymbal bus assigned to bus 7 and right cymbal assigned to bus 8. However the separate channels going into the DAW are sending the signal from either cymbal to both the DAW input channels.

Do I need a different splitter to achieve output separation from the PHONES channel?

I have done the UNIT setting correctly.

UT1.2 parameter to 1+2! and the the PHONS parameter to 7+8!

Thanks

This is the type of splitter:  http://www.sweetwater.com/store/detail/YPP117/
That is also the type of splitter if you ever split the tom inputs for adding additional pads.

[Jman]

Also, try setting your balance full left in the module for your left cymbal and full right on your right cymbal, just to check the results.

[mcrackins]

Excellent, thanks very much Jman, thought it might have been the adapter.

This is the type of splitter:  http://www.sweetwater.com/store/detail/YPP117/
That is also the type of splitter if you ever split the tom inputs for adding additional pads.