News:

2box forum: accident-free since the last one.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Zappmax

#1
Hi did you solve this i have the same problem
#2
Hi, assuming you did remove all screws knobs the last thing holding the pcb is just some adhesive tape close around the lcd screen. In my modul were only some fragments left maby because the module was at hyperactive a few week ago. Dont bend the pcb on the long side, hold is close to the screen on the short side  try to fix  the metal housing  somehow and then try to apply some warm air flow with a heatgun from outside close tho the metal hole for the lcd. But warm air not hot air you may start with 40C .

I dont know how to upload here a pic i have one were you could see were the tape is located

OF COUSE ALL IS ON YOUR OWN RISK😩😀
#3
I personally prefer custom in ears as first choice. But i use also the Beyerdynamics DT770 M 80Ohm. They have 35db external noisereducktion
#4
If i try to assign an additional closed hihat sound to a mono pad the pad plays always the open sound, i could not  find a way in the modul to select just the closed sound samples
#5
Yamaha rhh135 has the same problem the new sw .4 is even worser
#6
General 2Box Drumit 3 Forum / Re: Yamaha PCY-135
September 05, 2019, 05:29:55 PM
I had 2 pcy135 so i had to use them. I have no problems with the edge switches they work fine. My problem is the bell sound  which is very low even set tho "xyzH". If someone knows how to rise the Volume of the bell sounds within the dsnd files would be fine.
#7
Hi,

There are 2 sw versions on the web site of 2box. I had problems with the newer one to identify the rhh135 but the old one  works fine with one exception whenever you switch to another kit you have to first press the footswitch otherwise the hithat doesn not work.

Regards
Zappmax
#8
Hi i made some pics but before i saw this post, maybe it might help.

How  can i add pics here?

:-\
#9
Hi,  i am missing the choke switch im the schematics in the beginning has someone an updated version

Thx
#10
Yes
#11
General 2Box Drumit 3 Forum / Input differences
May 21, 2019, 07:15:37 PM
Hi,

is the snare labeled input electrically the same as a tom-x input( exept the 3 zone feature) Can i connect a  2 zone snare pad to a tom input and just set in units the rigth type? The  reason is i want to connect a yamaha 3zone pad to snare input have three different sounds and connect a bigger 2zone mesh pad with tom 4 and use it as snare.
#12
No i still use the old one because the new one doesnt store the Yamahe Hihat settings  at all.
#13
After installing the enerd drumkits on a bigger Sdcard each in an individually  folder, they appear between the kitnumbers 100-Ex-Ey...-1. Looks cool and i configured one of it with the standard cymbals and hihat but it doesnt store the hihat settings.

Don i have to overwrite one of the kits 1-100 to use the new sounds and store the settings?
#14
Seem‘s to be a known problem with usb stack of el capitan.
#15
Is it really not possible to use the metronom and the song player together?